Input
Measuring variable position
Stroke length 50…2500 mm Output
1. Voltage 0…10 VDC or 10…0 VDC, 0…10 VDC and 10…0 VDC (controller input resistance RL > 5 kOhms)
2. Current 4…20 mA or 20…4 mA (min/max. load: 0/500 Ohms)
3. Start/Stop RS-422 differential signal additionally available: serial parameter
upload of stroke length, offset, gradient, status and manufacturer number
Accuracy
Resolution analog: infinite
start/stop: controller dependent
Linearity 1 < ± 0.02 % F.S. (minimum ± 60 μm)
Repeatability < ± 0.005 % F.S. (minimum ± 20 μm)
Update time, stroke dependent analog: < 3 kHz / digital: controller dependent
Ripple analog: < 0.01 % F.S. / digital: controller dependent Operating conditions
Mounting position any
Magnet speed any
Operating temperature -40…+75 °C
Dew point, humidity 90 % rel. humidity, no condensation
Ingress protection 2 IP67, IP69K if mating cable connector is correctly fitted
Shock test 100 g (single shock) IEC-Standard 60068-2-27
Vibration test 15g / 10…2000 Hz IEC-Standard 60068-2-6 (resonance frequencies excluded)
EMC test electromagnetic emission EN 61000-6-4 (for use in industrial environment)
electromagnetic susceptibility EN 61000-6-2
the sensor meets the requirements of the EC directives and is marked with CE Design / Material
Sensor housing stainless steel 1.4305 / AISI 303; stainless steel 1.4404 / AISI 316L
Rod stainless steel 1.4306 / AISI 304L; stainless steel 1.4404 / AISI 316L for Ø 10 mm rod only
Pressure rating 7 mm rod: 300 bar, 450 bar peak
10 mm rod: 350 bar, 530 bar peak
Position magnet U-magnet, PA-Ferrite Installation
Mounting type threaded flange M18×1.5 or 3/4″ – 16 UNF – 3A
Mounting position any Electrical connection
Connection type 5 pin connector M12 (analog); 8 pin connector M12 (start/stop)
Supply voltage 24 VDC (+20 % / -15 %)
Current consumption 50…140 mA (digital 50…100 mA)
Ripple < 0.28 Vpp
Electric strength 500 VDC (DC ground to machine ground)
Polarity protection up to -30 VDC
Overvoltage protection up to 36 VDC
| 
